KNIPEX 35 31 115 - Electronics Pliers head mirror polished, handles with plastic grips

Electronics Pliers head mirror polished, handles with plastic grips.
Precision pliers for fine assembly work, e g. in electronics and fine mechanics.
Load-optimised for a more direct feel when working.
For gripping, holding and bending.
Sturdy, zero backlash box joint.
Smooth ground gripping surfaces.
Soft transitions.
No sharp edges.
Low-friction double spring for gentle and even opening.
The polish or mirror polish (only finish 2) together with a fine film of oil offer effective rust protection - no circuit faults caused by peeling chrome from plated tools.
Narrow sleeves pulled up to the head of the pliers enable the tool to be guided securely and comfortably, also between thumb and index finger.
Ball bearing chrome steel.

Small and fine: electronics pliers for fine installation work.
Short, smooth and good: 115 mm long for plenty of freedom of movement even where space is restricted.
Space is usually tight when working on electronic equipment, printed circuit boards and precision constructions such as measuring equipment or delicate apparatus.
A compact tool which can also be used to work well even in poorly accessible areas is therefore helpful.
With a length of just 115 mm and their slim, flat head, these 35 31 115 electronics pliers from Knipex are the ideal tool for the delicate gripping, holding and bending of sensitive components.
The gripping surfaces, which are rounded at the front, are smooth ground to protect sensitive surfaces.
With box joint design and double spring - smooth operating and accurateThe smaller and more sensitive the component being worked on, the greater the challenges placed on pliers.
The accurate, well-measured transmission of manual force to the component is vital.
The mechanics of the Knipex 35 31 115 are very finely adjusted.
The box joint is solid and smooth operating, because the inner handle is guided on both sides by the outer handle.
This ensures precise running without any tilting effect.
The low friction double spring supports the gentle opening of the pliers.
The handles of the Knipex 35 31 115 electronics pliers are forged from special tool steel, oil-hardened, carefully deburred, mirror-polished and completed with opening spring and rivet to produce gripping pliers.
Quality and safety are paramount - also regarding rust protection.
There is no chrome-plating on the Knipex 35 31 115, so that no pieces of chrome can peel off and fall onto printed circuit boards.
The mirror polish in conjunction with a fine oil film provides perfectly adequate corrosion protection for the pliers during workshop use.
The pliers are always protected if the oil film is replaced occasionally.
High Knipex quality standards and safety rust protection.
Small springs can be securely held, clamped and fed using the precisely machined tips.
Manual force can be carefully measured - ideal for sensitive components such as small toothed wheels.
With the Knipex 35 31 115 ESD, the wire ends on components are delicately bent.

 

• Handles: with non-slip plastic coating
• Head : mirror polished
• Head Width: 11 mm
• height: 17 mm
• Jaw Length: 22.5 mm
• Jaw Thickness: 6.5 mm
• Jaw Type: round jaws
• Joint Type: box joint
• length: 115 mm
• RoHs: No
• Standard DIN: DIN ISO 9655
• Style: round, pointed jaws
• Tip Thickness: 1 mm
• Tip Width: 2 mm
• Weight: 61 g
• width: 70 mm